Slow Worm Fencing
Slow Worm Fencing Specification
- Temporary Slow Worm fencing panel size; 3000 × 750 × 3mm green recycled polypropylene panels
- Permanent slow worm fencing panel size; 3000 × 750 × 4mm green recycled polypropylene panels
Slow Worm Fencing Fitted Measurements
Slow Worm fencing is installed 300mm vertically below ground, 375mm vertically above ground
Slow Worm Fencing Fitted Description
The slow worm fencing panels are fitted either into a 300 × 50mm slit created by a V backed sub soiler or “wiz" plough pulled by a tractor or in a trench excavated using a chain trencher or mini digger. Alternatively, if necessary, the trench is dug by hand.
The preferred slow worm fencing method for best results and most efficient fitment is the slitting method, where conditions suit. Once the slow worm fencing panels are sited the slit is closed up by driving back along the line of the newt fence with a tractor, vehicle or compacted by hand. This creates a total seal between the soil and the slow worm fencing panels, which are fitted to the side of the trench nearest to the relevant population or the inside if a containment area. The slow worm fencing panels are overlapped by 50mm then secured by aluminium blind rivets along the overlap joint. Slow worm fencing panels can be cut down or the overlap increased to allow for uneven ground or contours.
HERPETOSURE® slow worm fencing is designed to be reusable and recyclable, it also has a high level of impact resistance, therefore offering a much higher level of boundary security and removing the need to landfill expired fencing materials at the end of the project. ZERO project waste.
|Slow Worm Fencing Technical Data|
|Tensile strength (Mpa)||N/mm2||26.0|
|Elongation at break||%||460|
|Flexural modulus (Mpa)||N/mm2||1250|
|Linear Thermal expansion||mm/m/°c||0.150|
|Surface spread of flame||Class 3|